Leaf Eater Spinner Head
Replacement spinner head and 36 heavy duty cutting lines fits all Flowtron Leaf Eater models. The lines are in 6 strips of 6. To separate individual lines simply
pinch the indent between lines nearest strip end and peel away. This is a kit. Sorry, we do not sell the spinner head as a single item.
Fast and easy replacement,
includes spinner head, shaft and screw. Made in the USA and is the latest upgraded design. To maximize the life of your Flowtron Leaf Eater cutting line, install new lines as described below.
To remove used cutting lines, simply pull out through the ferrule hole and through the top post hole.
- Made in the USA
- Fast and easy replacement
- Includes spinner head, shaft and screw
- 36 cutting lines (6 strips of 6 lines)
- Latest design
- Fits all Leaf Eater models (LE-900, LE-800, LE-400)
Replacement of Spinner
- Remove screw and "O" ring from center of spinner head. (hold spinner in place while turning screw counter-clockwise).
- Lift spinner off shaft.
- Place new spinner over shaft and turn until hex falls in place.
- Tighten screw until "O" ring is depressed slightly.
- Replace cutting lines when a noticeable decrease in shredding efficiency is observed.
|
|
